AOR AR5001D Uživatelská příručka stáhnout pdf (Strana 53)

Using SignalTrack

Enter the data for each site as follows

 Site location can be entered by manually entering the latitude and longitude of the location or by

moving the mouse from the Site Editor dialog and clicking on the location on the map. The

location can always be moved by left clicking on the site and dragging it a new location

 Use the drop down list to select the receiver you will be using at the site. If you are using a

PCR1500 you must install the drivers for this device prior to using it in SignalTrack (see the

PCR1500 documentation for instructions on how to install the driver).

 The CIV address of the direction finder and the receiver. The CIV addresses are physical

addresses of the direction finder and receiver for each site must be unique across the entire

network. These addresses are set prior to deploying the direction finder and receiver to the

site. See direction finder networking for more details.

 Select the color you want to use for the site, the width of the bearing line to be drawn for the

site, and the size of the site

 The Slave ID is only used if SignalTrack is providing data to another site running another version

of SignalTrack via radio modem.

 For direct serial connections select the COM port the direction finder is connected to.

 For modem connections specify the COM port where the originating modem is connected, the

telephone number of the site, and any specific set up string required by the modem. The default

setup string is for the MutiTech DSVD modem.

The phone number can contain any of the following characters

0 - 9

P to indicate pulse dialing is to be used

Figure 26: Site Editor for Telephone Modem Connected Site

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 119 120

Žádné komentáře

AOR AR5001D Uživatelská příručka Strana 53